XEROX FUSER SYSTEM ERROR DOWNLOAD XEROX 5755

Xerox Fuser System Error Download Xerox 5755

Thanks to this site, I decided to replace just the thermistors on each printer.Where To Download Xerox 5755 System Administrator Guide Xerox 5755 System Administrator Guide Yeah, reviewing a book xerox 5755 system administrator guide could add your near contacts listings. One is several years old, but like new with only a few thousand impressions, the other purchased used with about 80,000 impressions. ERROR CODE C0510 ON BIZHUB C350 OR the fuser error code COPIER HP.I had 2 N2125 printers with this problem. System code, firmware, and drivers are available for download via the Konica Minolta. Fuser Heat Belt Unit Rebuild Kit (For repairing 126K34855 / 126K34854 / 126K34853 / 126K39440 / 001R00620) (Includes: Heat Belt, Slip Sheet, 25ml bottle of Heat Belt Oil, Applicator/Cleaning Cloth, & Index Card) For rebuilding the Heat Belt Unit if the belt gets. For use in Xerox brand: V80, V180, V2100, V3100 Heat Belt Modules.

Tech Info Center.I found an eBay source for the thermistors - just search for N2125 thermistor.To install, remove the Fuser assembly by first opening the rear door. (Also replaces 126K16480, 126K24984, 604K20342, 604K20343, 622S00191) Note that the OEM Refurbished part number is 126K38640, see Related Products for rebuilt fuser choice) Tech Info. In the System Configuration Utility dialog box, click the Fuser Assembly, Genuine XeroxВ®: 126K24954 / 126K16481 / 604K20344. Replace the Fuser Assembly.

You will see the thermistor attached to the underside of the top. Remove the 4 screws holding the top on and remove the top. Remove the screws holding the red and white wires to the top, and the single screw holding the heater element on the opposite side. Remove the 2 screws holding each end cap in place and while working the wires loose, remove the end caps.

It was about $3.- Replaced the fuse, put it back together, and it's been working for a few days so far.I realize I am resurrecting an old thread, but it was this thread that helped me fix my GCC Elite 21DN (essentially a clone of the 2125 with a different speed processor). The original fuse operated between 169 - 172 degrees Celsius, and the replacement I found was 170 degrees Celsius. It was the thermal fuse that had blown.- Further reading on the net revealed that the fuse apparently gets worn down over time, and the higher resistance due to copper oxidation probably created more heat as well inside the fuser.- Trying to find that fuse was not easy, but eventually found a distributor that sells a compatible but not the exact replacement here in town. I sanded off the contact points until they were shiny.- Put it back together, still didn't work.- Reopened the fuser cover, noticed a resistor-like device that said 'SE FUSE.' Took it out and it measured open.

In searching I also found a cheap supply of OEM IBM toner that works fine as long as I change the little plate that sits on top of the cartridge to match the sensor in my printer (it seems the IBM InfoPrint 21 clone used a different plastic piece, but otherwise the toner cartridge is the same. The information helped me repair a great printer at a very low cost. Just repaired today).Thank you everyone who posted here from all the way back in 2006 or so. BUT IT WORKED!So now my printer seems to be working fine again (not time tested yet.